Panel Plug and Socket Shells
Panel plugs and sockets feature the same rear sealing arrangement. Again, the retaining ring may be discarded in favour of a backshell if required.
Neptune
Based on Trident Ringlok series, the Neptune range combines power and signal contacts. Widely used in automotive, marine and process control industries, they feature a strong bayonet coupling system with standard and reversed pin/socket combinations. A wide selection of backshell accessories, rear housings and dust caps are available.,To maintain IP67 rating the rear of the connectors have a rubber seal which is pierced upon contact insertion. The seal is held in place by a screw ring (as supplied) which may be replaced with the appropriate size backshell. For IP67 rating to be maintained, wire insulation diameters should be within the following diameters: Signal wires: 1.7 to 2.7mm, Power wires : 2.7 to 4.0mm.,Number of contacts shown as power/signal eg 2//13.
Current Rating (single contact)
13A signal contacts, 30A power contacts
Voltage Rating
30V
Contact Resistance
5mΩ max
Test Voltage
2000V rms
Insulation Resistance
5000MΩ min. at 500V dc
Operating Temperature
-55 → +120ºC
Seals
Rubber
Housings
Nylon to UL94 V-0
Coupling Rings
Nickel plated brass or plastic version
Contacts
High conductivity copper alloy
Contact Plating
Gold (contact area)
Mating Cycles
Dimensions (mm)
Shell 24
Shell 16
Shell 14
Dia mm
43.2
30.5
28.5
Hole dia. to flat
41.5
28.0
24.5