Discounted Products

FLOATSWITCH HORZ .6A POLYPROP

Calibration/ Substitution, 8 Decade-Thumb Wheel Resistance Boxes For simulating resistance transducers and for laboratory, industrial and educational use. Required resistance is set by clearly marked thumbwheel switches, colour coded to aid identification.Model10511040Zero residual resistanceAccuracy100 to 100 k10 M decade: 1cades: 0.10 to 1 M10 decades: 0.5cades: 0.1ecades: 1 decades: 0.5%0.1 decades: 5ecade: 1%0.01 decades: 10%Temperature coefficient100 p.p.m./C50 p.p.m./C

JUMPER SXH-001T-P0.6 X2 10"

CONN PLUG HSNG MALE 6POS INLINE

JST YL Series Receptacle Housings A range of multi-pole receptacles from the JST YL series of wire-to-wire connectors. The receptacles are intended for use with crimp pin contacts, RS 392-2666 . Voltage and current ratings are dependent on wire size used. • Suitable wire size: 26 to 20 AWG (0.13 to 0.5 mm2) • Maximum working voltage: 300V • Maximum current rating: 10A • UL, CSA, and TUV approvals 4.5mm wire-to-wire JST YL Series A range of JST YL series 4.5mm pitch wire-to-wire crimp style connectors

Rosemount 2120 Vibrating Level Switch The 2120 is a popular choice for its simplicity, ease-of-use, and reliability, in high and low level alarm applications. When used as a low level alarm, the liquid in the tank or pipe drains down past the fork, causing a change of natural frequency that is detected by the electronics and switches the output state. When used as a high level alarm, the liquid rises in the tank or pipe, making contact with the fork which then causes the output state to switch. 8/16 mA (’Off’/’On’), Direct Load, PNP, Relay, or NAMUR switched output electronics (depending on version) Threaded process connection for side, top, or bottom mounting 2 off M20 conduit entries for supplied cable gland and blanking plug (cable not supplied) Easy selection of Dry ’On’ or Wet ’On’ Mode and Switching Delay Magnetic test point makes functional test easy Vibrating Liquid Level Switches

LED Indicators, 8mm Mounting, 12/24Vac/dc, OXL/CLH/80 Series Oxley OXL/CLH/80 series LED indicators are designed specifically to meet the needs of the commercial market sector. Oxley OXL/CLH/80 series panel lamps ensure high reliability with MTBF in excess of 90,000 hours and complete ’fit for function’ practicality allowing a cost efficient solution that combines optical performance with terminal and voltage options. Recessed natural aluminium or prominent black nickel housing Integral resistor Standard or high intensity LEDs 8mm mounting Sealing up to IP68

RG179 B/U FEP RG179 coaxial cable Applications Applications include: Commercial Electronics and radio frequency engineering Standards MIL-C-17F, MIL-C-17G

DOUBLE SIDED FOAM TAPE, 24MM X 5M

CAP TANT 10UF 35V 10% 2312

GRAVITY: DIGITAL SPEAKER MODULE

Low Smoke Halogen Free Single Core Cable - H07Z-K A flexible low smoke halogen free single core cable for internal wiring Intended for installation within conduits and trunking, as well as internal wiring within appliances and fittings Can be used in all areas where in an event of fire a protection of people and equipment is paramount Flame retardant in accordance to IEC 60332-1-2 Smoke density in accordance to IEC 61034 Halogen free in accordance to IEC 60754-1 Working voltage 450/750V Test Voltage 2500Vac Temperature range -15°C → +90°C

100W Universal Input, Adjustable Output, Switch Mode Power Supply, TPI 150 Series The Traco Power TPI series of AC-DC power supplies feature reinforced double I/O isolation system, according to the latest industrial safety standards. This Power supply has an excellent efficiency up to 92% which allows high power density for the standard packaging format. The full load operating temperature range of this AC-DC power supply is -40°C to 50°C, going up to 70°C with 50% load derating. The TPI series of power supplies comes with active power factor correction and EMC characteristic dedicated for applications in industrial and domestic fields. The power supplies are built using industrial quality grade components and excellent thermal management, which guarantees their reliability. Ideal applications of the TPI series of Power supplies are in demanding industrial devices and space critical applications. Highest power density encased 100W power supply in 2 x 4 package I/O reinforced isolation 3000Vdc Ready to meet ErP directive, Highest efficiency 91 to 92% across 10% – 100% load range Active power factor correction (>95) Protection class II prepared Operating up to 5000m altitude Adjustable output voltage Approvals ERP, CE, CB, UL/cUL Standards UL/cUL 60950-1, IEC/EN 60950-1 Switch Mode - Traco TPI Series

Mobrey Level Switch The Mobrey ultrasonic liquid level switch with polyphenylene sulphide construction has output type integral SPCO relay (energised when the sensor is wet) and 1-in BSPT dual mount thread. This switch is designed for high or low-level alarm duties to give a voltage-free contact or solid-state transistor output for alarm signalling or as part of a pump control system. It is intended for level detection at a fixed point when liquid fills the gap between the crystals. The supply voltage ranges between 18VAC/DC and 30VAC/DCNote:If the liquid to be monitored is flowing, the device should be fitted with the gap inline with the flow. In storage tanks, it should be fitted with the gap vertical unless the liquid is highly aerated when it should be angled.Features and Benefits Vessel pressure of 5bar (maximum)Wet switching level detection at a fixed point when liquid fills the gap between the crystalsSwitched voltage is 30VDC (maximum)Suitable for low maintenance applicationsHigh reliability with no moving partsNot easily subject to fouling and not affected by ambient light conditionsFitted with three metres of cableLightweightNo moving partsMounting types are horizontal and verticalApplications Low level alarms in header tanksPump control duty in feeder tanksHigh and low alarms in storage tanksLevel and pump control in storage tanksSmall or thin wall tanksBund level detectionSteering gear oilCertifications NEMA 6P (10ft.)/IP66/IP68 (3m)

SPEAKER 8OHM 1W TOP PORT 92DB

LED COB VERO 18 3000K ROUND

3 ROW M/T FEMALE SM/B CRIMP

PANEL CONTROL - 9MM-ST-CARBON

Chassis Socket/Plug From Amphenol, this 62GB/LC series panel mounted chassis socket features bayonet connection for quick and reliable connecting. Available as either a plug or socket, the 62GB/LC series comes in a variety of shell sizes. Note Cable mount plugs will only mate with chassis mount sockets, and cable mount sockets will only mate with chassis mount plugs. Standards BS9522 F0017; MIL-C-26482 Amphenol BLZC (Black Zinc) Black zinc cobalt plated bayonet locking connectors that are interconnectable and interchangeable with connectors that conform to MIL-C-26482 and BS9522 F0017 requirements. Of a commercial grade they are machined from aluminium alloy and provide durability and resilience in industrial environments. The black plating offers an aesthetically pleasing finish to the connectors. Connector pins and sockets are prefitted solder bucket type.,The cable plugs are supplied complete with backshell.These connectors will also take the spin coupling backshells (stock no. 241-1294 - typically) and have the same thread as 62GB connectors.

SolaHD Hazardous Location Transformers These heavy-duty encapsulated transformers have been designed for use in hazardous locations (Class 1, Division 2, Group A-D). They are also suited to harsh industrial environments. The encapsulation and rugged NEMA 3R enclosures help to provide protection from dust, moisture and also provide extra shock and vibration resistance. Available in both single and 3 phase options. Rated for hazardous locations and harsh industrial environments UL listed Available in both single and 3 phase options Single phase: 0.05 kVA to 0.250 kVA Single Phase: (0.50 → 25 kVA), 3 Phase (3 → 45 kVA) Conduit knockouts for side entry into roomy wiring compartment Copper lead wire terminations 0.500 kVA → 10 kVA units are encapsulated with electrical grade silica sand and epoxy for industrial applications

SIBA HBC Ceramic Cartridge Fuse Type gR SIBA cylindrical ultra-rapid fuses are available in six different sizes. They can be fitted with or without a built-in striker pin for fuse blown indication or operation of microswitches. High interrupting rating up to 300 kA Voltage rating AC 250 V to AC 1000 V Protection of Power Semiconductors according to IEC 60269-1 and -4 Available with integrated striker pin Classes according to IEC 60269-4 and DIN VDE 0636-40 Fuse-holder / fuse-clips and accessories are available Standards IEC 60269-4; DIN VDE 0636 Teil 40 and UL248-13 Approvals IEC 60269 - 4; DIN VDE 0636 Teil 40; UL 248 - 13

TIMER SS MINI DPDT 10SECONDS

CBL PLUG-OF-NAILS TO CORTEX SWD

M12 Right Angle IDC Connector