Extensions with metal holes
This range of PTH extension boards is available in two combinations: standard and super.
The standard 64 // 64 range is assembled with a DIN connector (front and back), and is supplied with ejector levers. The super version has a 96 // 96 connector and is supplied with all standard extension pieces plus gold-plated wrapping terminals, a connection pad and a DIN logic analyser reverse connector.
Height can be extended in multiples of 3U, thanks to the addition of an intermediate plate.
Compatible with systems 160 and 220 mm deep.
Voltage and current can be measured by a complete super version assembly or by simple division of the tracks and fitting of pins to allow the addition of connecting jumper switches.
Material:
epoxy glass in compliance with BS 4584
EP-GC-Cu3 FR4
Nominal thickness:
1.6 mm
Copper thickness
- laminated: 35 μm
- plated: 25 μm
Tinning:
10 μm
Max. operating temperature:
+155 °C
Stock
no.
description
502-168
Standard 64 // 64 extension board
200-0018
Standard 96 // 96 extension board
546-0205
Super 96 // 96 extension board
501-288
Set of multiple intermediate plates
PC / VME Bus Boards
PC Compatible Prototyping Boards
Prototyping boards manufactured from epoxy glass material to BS 4584 part 3 or 16. Card thickness is 1.6 mm. Copper is 305 g/m (1 oz/ft). Edge connector fingers are gold plated to a thickness of 1.5 microns. 1.0 mm (0.040 in.). Diameter holes are pre-drilled on a 2.54 mm (0.1 in.) matrix.
Microboard Pattern
Incorporates, on the component side of the card, a colander ground plane for maximum screening and glitch free high speed operation, and complete solder mask protection.
