Bearing Induction Heater
Avaialble in 230V version (RS
4979584)
and 110V version (RS
6808018
)
SKF induction coil Bearing Heaters designed to carefully and evenly heat bearings that are mounted with an interference fit onto a shaft. Bearing heaters allow bearings to be installed without the need for specific hand tools. They eliminate the need for force to be applied to the bearing during installation. Bearing heaters can be used to heat other engineering components, such as gears, pulleys, bushes, where the bearing heater-component being heated forms a closed electrical circuit. The induction coil is housed outside the heater housing, providing a shorter heating time and reduced energy consumption during use. Foldable bearing support arms facilitate the heating of larger bearings/other suitable components, and a magnetic temperature probe helps prevent overheating. The heaters feature an integrated, easy-to-use control panel and handset/remote control. An integrated carrying handle is built into the bearing heater design, and each heater comes complete with three yokes.
Features and Benefits
2-step power setting and smaller yokes allow heating smaller bearings safely and at lower power consumption
Temperature mode pre-set at 110°C to prevent over-heating
Automatic demagnetisation
Capable of heating a 28kg bearing in 20 min
Compact lightweight design facilitating portability
The TIH 100m has the same capabilities as the smaller heater but with increased capacity. The advanced design of the power electronics allows accurate electric current control.
Technical Specification
Voltage
230V, 50-60Hz
Workpiece
Max. Weight
40kg (88lb)
Bore Range
20-300mm (0.8-11.8in.)
Dimensions
450 x 195 x 210mm
Total Weight (inc. yokes)
20.9kg (46lb)
Max. Power Consumption
2.0kVA
Standard Yokes Sup...
