Parallel Wiring Module
It is possible using parallel wiring to connect a TeSys U starter to a PLC I/O module to transfer status and command information
Fits directly into a Power Base module
It must be used with a 24Vdc control Unit e.g Stock No.
493-8987
(LUCB 1XBL)
Each Module has 4 channels, 2 outputs for starter forward and reverse running,3 inputs for knob position, fault indication and position of poles
Interconnection to the PLC I/O module is via a RJ45 connector, ready leads are available e.g. Stock No.
493-9233
(LU9R03)
Schneider Electric TeSys U
The TeSys U is a modular system for motor control; it enables the user to create a customised solution for their control requirements, from a series of standard modules. The plug-in modules allow the assembly and wiring before the selection of motor protection parameters and control voltages, they can be created or changed in seconds by changing the plug-in modules. A host of DOL starting applications can be catered for.
Faster design with fewer components needed
Quicker panel build with faster assembly time and fewer wires per starter
Space saving 45mm width up to 32A (even for reversing) allowing smaller panels
Flexible and upgradeable with plug-and-play function modules
Voltage and protection parameters can be determined after assembly and wiring
Broad band electronic control unit provides improved overload protection with fewer components
Expandable plug-and–play diagnostics
Total co-ordination for fast return to service after a short circuit fault
Tesys model U is easy to select:
First choose a Power Base- 12A or 32A, direct on line or reversing. The power base includes 2 auxiliary contacts.
Then choose the plug-in protection module by motor full load current and control voltage required.
Additional plug in functions can be selected and added at any time.
The plug-in bases can use ...
